Enerpac 2000 Série Notice D'emploi

EIS 61.109-2 01/'99 Rev. A
index:
GB
GB
Instruction Sheet............................................................page ...........1-4
F
F
Notice d'Emploi..............................................................page ...........5-8
D
D
Bedienungsanleitung .....................................................Seite .........9-12
I
I
Manuale Istruzioni..........................................................pagina ....13-16
E
E
Instrucciones..................................................................página ....17-20
NL
NL
Gebruikershandleiding ...................................................pagina ....21-24
1.0 IMPORTANT RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage.
Shipping damage is not covered by warranty. If
shipping damage is found notify carrier at once. The
carrier is responsible for all repair and replacement
costs resulting from damage in shipment.
SAFETY FIRST
Read all instructions, warnings and cautions
carefully. Follow all safety precautions carefully to
avoid personal injury or property damage during
system operation. Enerpac cannot be responsible for
damage or injury resulting from unsafe product use,
lack of maintenance or incorrect product and/or
system operation. Contact Enerpac when in doubt as
to the safety precautions and applications.
TO PROTECT YOUR WARRANTY, USE ONLY
ENERPAC HYDRAULIC OIL.
2.0 GENERAL SAFETY ISSUES
Failure to comply with following cautions and warnings
could cause equipment damage or personal injury.
CAUTION: DO NOT use combustible
gasses to power an air-driven pump.
IMPORTANT: Use hydraulic gauges in
each hydraulic system to indicate safe
operating loads.
Instruction Sheet
2000, 3000 and 5000
®
series Hushh Pumps
heat, flame, moving machine parts, sharp edges and
corrosive chemicals.
If oil is injected under the skin, see a doctor
immediately.
1
WARNING: Make sure that all system
components are protected from external
sources of damage, such as excessive
CAUTION: Avoid sharp bends and kinks
in hoses which will cause severe back-up
pressure. Also, bends and kinks lead to
premature hose failure damage.
DANGER: Do not handle pressurized
hoses. Escaping oil under pressure can
penetrate the skin, causing serious injury.
WARNING: Never
uncoupled couplers. Only use hydraulic
equipment in a coupled system.
WARNING: To avoid personal injury and
equipment damage
hydraulic components withstand the max.
hydraulic pressure of 700 bar.
WARNING: Immediately replace worn or
damaged parts by genuine Enerpac parts.
Standard grade parts will break causing
personal injury and property damage.
pressurize
make sure all