Installation Clearances; Installation - IKEA LAGAN Mode D'emploi

EN
This Use & Care Guide provides general
operating instructions for your model.
Use the appliance only as instructed in
this Use & Care Guide. Before starting the
unit, follow these important first steps.
Location
• Choose a place that is near a
grounded electrical outlet. Do Not
use an extension cord or an
adapter plug.
• If possible, place the appliance out
of direct sunlight and away from the
range, dishwasher or other
heat sources.
• You must install the unit on a floor
that is level and strong enough to
support a fully loaded appliance.
• If you plan to purchase an ice
maker kit (optional, not included),
consider water supply availability
near the appliance.

Installation

Installation clearances

• Allow the following clearances
for ease of installation, proper
air circulation, and plumbing and
electrical connections:
Top
Sides
Back
NOTE
If you place the refrigerator with the
door hinge side against a wall, you may
have to allow additional space for the
handle so you can open the door wider.
3.94 in. 100 mm
1.57 in. 40 mm
1.18 in. 30 mm
INSTALLATION
Guidelines for final positioning of
your unit:
• Rest all 4 corners of the cabinet
firmly on the floor.
• Level the cabinet at the front and rear.
• The sides should tilt ¼ in. (6 mm)
from front to back (to ensure the
doors close and seal properly).
• Align the doors with each other and
level them.
Setting the Anti-tip bracket:
The Anti-tip brackets are located on the
lower front corners of the cabinet. Lower
the anti-tip on each side clockwise until
they contact the floor. Do not raise
the cabinet.
Lower
Anti-Tip Bracket
WARNING
You must install the anti-
tip bracket according to the
instructions in your Use &
Care Manual. Failure to do
so will result in injury.
9