Receiving And Inspecting The Equipment; Storage; Unpacking; Lifting And Handling - Parker BAM10 Mode D'emploi

2.5 Receiving and Inspecting the Equipment

The equipment is supplied in a sturdy wooden crate designed to be moved using a forklift truck or pallet truck. On delivery of the equipment check
the crate and its contents for damage and verify that the following items have been included with the dryer. If there are any signs of damage to the
crate please inform the delivery company immediately and contact your local Parker domnick hunter office.

2.5.1 Storage

The equipment should be stored, within the packing crate, in a clean dry environment. If the crate is stored in an area where the environmental
conditions fall outside of those specified in the technical specification, it should be moved to its final location (installation site) and left to stabilise
prior to unpacking. Failure to do this could cause condensing humidity and potential failure of the equipment.

2.5.2 Unpacking

The panels of the crate are secured using nails. Starting with the top, carefully remove each panel in turn and store them safely for future use.

2.5.3 Lifting and Handling

Lifting pockets have been provided on the module to facilitate lifting with a fork lift truck. The centre of gravity for the modules are illustrated below.
H
W D
Centre of Gravity
Model H
mm ins
691 27.2
BAM10
745 29.3
BAM20
828 32.6
BAM30
859 33.8
BAM40
878 34.6
BAM50
925 36.4
BAM70
W D
mm ins mm ins
599 23.6 655 25.8
622 24.5 663 26.1
598 23.5 702 27.6
619 24.4 722 28.4
615 24.2 860 33.9
661 26.0 931 36.7
7