Related Products; Connection Of The Safety Earthing; Switching On - Videotec MAXIMUS MBX Manuel D'instructions

Arrange the fibre optics as indicated in the figure,
use the plastic clips supplied to fasten the fibre optic
bundle (Fig. 8, page 15).
Fig. 8
Position the splice tray in place and fasten it using the
specific screws (Fig. 9, page 15).
Fig. 9
MNVCMBXSW_2222_EN

7.2.10 Related products

MAXIMUS MBX exclusively supports
VIDEOTEC products from the MAXIMUS
range with 24Vac and WASEX with 24Vac.
Check the requirements of the device to connect in
the relevant instructions manual.
7.3 Connection of the safety
earthing
The ground conductor should be equal or
greater in section than the section of the
power supply cables.
Earth cable should be about 10mm longer
than the other two, so that it will not be
disconnected accidentally if pulled.
The equipment must be connected to a ground
conductor (safety ground). This connection must only
be performed through the power line connector (J1,
7.2.1 Connector board description, page 11).

8 Switching on

Read the product Manual A before
performing any operation.
The unit is switched on by connecting the power
supply.
To switch off the unit disconnect the power.
15