How To Set Up The System; Configuration Example 1: Connection Of Camera Controller - Panasonic AK-HC1500G Mode D'emploi

How to set up the system

Configuration example 1: Connection of camera controller
 Use multi cable supplied with AK-HRP150 for the connection of camera controller
AK-HRP150 and this unit.
Lens
AC adapter
AW-PS505A
 Before connecting the cables, be sure to set the power switch of AC adapter to OFF.
 Connect the multi cable to the interface connector of the camera, and the opposite
side to camera controller.
 Set the AC adapter power switch to ON, then the camera can be controlled.
 After shooting, set the AC adapter power switch to OFF.
AK-HC1500
Select "1" as the PROTOCOL
setting.
IRIS
Multi cable
(POWER + CONTROL)
- 1 (E) -
HD SDI OUT
Monitor
Camera controller
AK-HRP150