Disk Guard; Installation And Setting; Operation - MeisterCraft MWS 650 Manuel D'utilisation

5455060-Winkelschl-man_a 31.01.12 14:09 Seite 92
7 – Installation and setting

Disk guard

The position of the disc cover (3) can be
adapted to suit the relevant working
conditions. To do this, loosen the screw
(12) with a screwdriver and turn the
cover to the new position. Tighten the
screw back up again (fig. 3).
CAUTION! The closed part of the
disk guard should always point
towards the user to protect him from
sparks and chippings.
Mounting and removing the disc
cover
If necessary and if the situation requires,
the disc cover can be removed
completely. To do this, loosen the screw
(12) in such a way that the cover can be
removed by turning it out of the guide
groove of the grinding head.
To mount the disc cover, follow
instructions in reverse order.
Additional grip
Depending on the working method, the
additional handle (2) can be mounted in
three different positions on the grinding
head (fig. 4).
Mounting tools
CAUTION! Before working on the
machine, always pull out the
power plug!
Cutting and roughing disks
All types of grinding and cutting disks
(elbowed A/B, flat, and 'diamond' C) can
be mounted on the spindle (6) (fig. 2).
92
Depending on type and thickness of the
disk, always select a suitable
arrangement of clamping disk (7) and
nut (8).
Press the spindle-locking button (4)
in deep and hold it in this position.
If necessary, turn the spindle
slightly with the free hand until it locks
into position. Tighten the clamping nut
with the flange key provided (fig. 5). Do
not work with disks thicker than 6 mm.
CAUTION! Allow disks to cool
down before changing them.
HOT! Always work with the disk guard
in position!
CAUTION! With accessories,
always comply with the
manufacturer's directions. The
maximum rotation speed must be
greater than the idling speed of the
machine.
8 – Operation
Switching on (fig. 8)
Push the sliding switch to I (ON) (a). To
work with both hands, allow it to click
into place (b).
Switching off (fig. 8)
Release the sliding switch, it locked in
place, gently press the rear section of
the sliding switch (c). The switch will
jump to O (OFF). Only put the machine
down after it has come to a complete
standstill.
Test run
CAUTION! Always carry out a test
run before starting work and after
every tool change!