Safety Instructions Relating Specifically To The Equipment - MeisterCraft MWS 650 Manuel D'utilisation

5455060-Winkelschl-man_a 31.01.12 14:09 Seite 90
CAUTION! A spindle lock is
located on the upper side of the
unit. Never press the spindle lock
while the grinding body is rotating.
CAUTION! Do not use any
reinforced straight grinding
discs, reinforced grinding discs and
grinding cup wheels.
Handling, transportation and storage
of grinding discs:
Grinding discs are fragile and sensitive
to impacts and bumps. For this reason,
special care must be taken:
a) Never drop discs and avoid sudden
impact.
b) Do not use dropped or damaged
discs.
c) Avoid vibrations or bumps during
work.
d) Avoid damages to the holder hole.
e) Avoid putting loads onto the disc
surface.
f) Store grinding discs either flat or
upright, dry, frost-free and at a
constant medium temperature.
g) Store grinding discs in the original
packaging or in special containers
and on shelves.
6 – Safety instructions
relating specifically to
the equipment
• For power tools with the X connection
type that require a specially set-up
connection cable to exchange the
90
connection cable: When the
connection cable of the power tool is
damaged it must be replaced by a
specially set-up connection cable that
may be obtained via the customer
service organisation.s
• Before changing the tool or carrying
out maintenance work, pull out the
power plug and wait until motor and
spindle have come to rest.
• Do not press the spindle lock until
motor and spindle have come to rest.
• Do not use cutting disks which
exceed the maximum diameter stated.
• When fixing accessory tools to the
machine, note the correct direction of
rotation of machine and accessory.
• The permitted rotation speed of the
accessory tool must not be less than
the idling speed of the machine.
• If necessary, wear hand, eye and ear
protection.
• Switch the machine on immediately
before contact with workpiece.
• Never lay the machine aside when it
is still running.
• Secure workpiece with clamps etc.
• Never use cutting disks for rough
grinding.
• Always store and handle grinding
disks carefully in accordance with the
manufacturer's directions.
• Check disks before using them. Never
use chipped, cracked or otherwise
damaged products.