Water Supply - AGA marvel MO24RFS Instructions D'installation, D'utilisation Et D'entretien

An optional ice-maker kit (part number S42418151) is
available for model MO24RF which includes all of the
necessary parts for installation. The kit can be obtained from
Marvel customer service by calling 800-223-3900.

Water Supply

!
CAUTION
building codes when installing this appliance.
⁄
Use " copper tubing for your water supply which is available
1
4
at any local hardware or plumbing supply store. Bend the
copper tubing to suit your installation being sure not to kink
the tubing. Purchase enough copper tubing length and coil it
behind the unit to form a "service loop" which will allow the
appliance to be pulled out from the installation for servicing or
cleaning. Connect the copper tubing to the "top side" of a
cold water pipe to prevent the ice-maker from plugging with
sediment.
A shutoff valve is recommended on the water supply line to
ease servicing the appliance. NOTE: A SELF-PIERCING
TYPE VALVE IS NOT RECOMMENDED as they are prone
to clogging with sediment which will create pressure drop
reducing the water supply to the unit.
Connect the copper tubing water supply to the brass union
with a 1/4" compression nut fitting. (See Figure 7).
Water pressure must be at a minimum of 20 psi for proper
operation and a maximum of 120 psi.
Make certain all water connections are watertight after installation. Form the tubing so that it will not
vibrate against the cabinet body or kink when your appliance is set in position.
•
Do not use any thread sealers on these water line fittings.
•
Reverse osmosis, softened water, and de-ionized water are not recommended as they will adversely affect the quality
of the ice.
Observe and
follow all local
⁄
1 "
4
⁄
1 " copper tubing
4
8
NOTE