Care And Cleaning And Energy Saving Tips - AGA marvel MO24RFS Instructions D'installation, D'utilisation Et D'entretien

Spacer
Grille

CARE AND CLEANING AND ENERGY SAVING TIPS

Access
cover
around perimeter of
access cover.
!
CAUTION
The water supply to the ice-maker must be turned on prior
to turning the ice-maker on. Failure to do so will cause
Energy saving tips:
The following suggestions will minimize the
cost of operating your refrigeration
appliance.
1. Do not install your appliance next to a hot appliance
(cooker, dishwasher, etc.), heating air duct, or other
heat sources.
2. Install product out of direct sunlight.
3. Ensure the front grille vents at front of appliance
beneath door are not obstructed and kept clean to
allow ventilation for the refrigeration system to expel
heat.
rapid dry cycling of the ice-maker mold heater resulting in
temperature control issues in the freezer compartment.
water line
Start-Up After Long-Term Storage:
1. If stored outside, it is recommended that the unit again
be thoroughly inspected per the storage instructions
above to address any dirt or debris from the weather
and/or animals/insects.
To disconnect the water outlet line: Push up on the
white collar and pull the plastic water line from the bottom
of the water valve.
To reconnect the water outlet line: Simply insert the
plastic tubing into the white collar and push until it stops
⁄
(about 1 ", 12 mm, of water line will enter the valve).
2
4. Plug your appliance into a dedicated power circuit.
(Not shared with other appliances).
5. When initially loading your new product, or whenever
large quantities of warm contents are placed within
refrigerated storage compartment, minimize door
openings for the next 12 hours to allow contents to pull
down to compartment set temperature.
6. Maintaining a relatively full storage compartment will
require less appliance run time than an empty
compartment.
7. Ensure door closing is not obstructed by contents
stored in your appliance.
23