Troubleshooting Ice-Maker - AGA marvel MO24RFS Instructions D'installation, D'utilisation Et D'entretien

• Replace all parts and panels before operating.
TROUBLESHOOTING OPTIONAL ICE-MAKER
Problem
Appliance not cold enough
(See "Adjusting the temperature" on page 11)
Appliance too cold
(See "Adjusting the Temperature" on page 11)
No interior light.
Light will not go out when door is closed
Noise or Vibration
Appliance will not run.
Problem
Unit operates but produces little or no
ice.
Possible Cause
•
Control set too warm
•
Content temperature not stabilized.
•
Excessive usage or prolonged door
openings.
•
Airflow to front grille blocked.
•
Door gasket not sealing properly.
•
Control set too cold
•
Door gasket not sealing properly.
•
Failed LED light assembly or light switch.
•
Door not activating light switch.
•
Failed light switch
•
Appliance not level
•
Fan hitting tube obstruction.
•
Appliance turned off
•
Power cord not plugged in.
•
No power at outlet.
Possible Cause
•
The unit has just been started and
it has been less than 24 hours.
•
Water supply is not turned on.
•
Inadequate water pressure to unit.
•
The ice-maker shut off arm is in
the uppermost / off position.
•
Freezer section has not reached
temperature.
•
Thermostat control set too warm.
27
Remedy
•
Adjust temperature colder. Allow 24 hours
for temperature to stabilize.
•
Allow temperature to stabilize for at least
24 hours.
•
Airflow must not be obstructed to front
grille. See "clearances" on page 4.
•
Replace door gasket.
•
Adjust temperature warmer. Allow 24
hours for temperature to stabilize.
•
Replace door gasket.
•
Contact a qualified service technician.
•
Appliance not level, level appliance, (See
page 4, "leveling legs")
•
Contact a qualified service technician.
• Level appliance, see "Leveling Legs" on
page 4.
•
Contact a qualified service technician.
• Turn appliance on. See "Starting your
appliance" on page 10.
•
Plug in power cord.
•
Check house circuit.
Remedy
•
Typical ice production is 6 to 7
pounds per day. Allow for the
freezer section to reach
temperature and the ice-maker to
cycle and accumulate ice.
•
Turn on water supply to the unit.
•
Water pressure to the unit must be
at a minimum of 20 psi.
•
When the ice-maker shut off arm
is in the uppermost position, the
ice-maker is off. Flip the shut off
arm down to turn on the ice maker.
•
Allow the freezer section to reach
temperature.
•
Turn the temperature control to a
higher number to allow the unit to
run colder. Allow 24 hours before
readjusting the temperature
control.