Setup - Chauvet DJ EZ LASER RB Mode D'emploi

3. S
ETUP
AC Power
Charging the
Battery
Battery
Runtime
Battery
Maintenance
Page 10 of 48
The EZ Laser RGFX/RB has an external auto-ranging power supply and it can
work with an input voltage range of 100 to 240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet,
and wiring), use the current value listed on the label affixed to the product's
back panel, or refer to the
indicates the product's average current draw under normal conditions.
· Always connect the product to a protected circuit (circuit breaker or
fuse). Make sure the product has an appropriate electrical ground to
avoid the risk of electrocution or fire.
· To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer
circuit, even if the rheostat or dimmer channel serves only as a 0 to 100%
switch.
The EZ Laser RGFX/RB comes with a rechargeable lithium battery for cable-
free operation.
To charge the battery, simply plug in the power cord at any time before, during,
or after operation.
The EZ Laser RGFX/RB battery should be charged 24 hours prior to initial
use for optimal battery life.
The maximum runtime for the EZ Laser RGFX/RB battery is up to 6 hours;
however, the operation mode used has a bearing on the final runtime for the
battery. To achieve the maximum battery runtime, set the product in the Sound-
Active modes only. When using the Auto Program modes, the battery runtime
may be shortened.
To keep the battery in optimal operating condition, store the product in a cool,
dry place and charge at least once every 30 days when not in use.
Avoid exposure to extreme temperatures. If the product is exposed to extreme
cold or hot temperatures, warm-up / cool-down the product before use and
before charging.
Technical Specifications. The listed current rating
EZ Laser RGFX/RB User Manual Rev. 2