Setup; Ac Power; Fuse Replacement; Fuse Replacement Diagram - Chauvet DJ Motion Orb Mode D'emploi

3. S
ETUP

AC Power

Fuse
Replacement
Fuse
Replacement
Diagram
MotionOrb User Manual Rev. 66
The MotionOrb has an internal auto-ranging power supply that works with an input voltage
range of 100 to 240 VAC, 50/60 Hz.
To determine the product's power requirements see the product label, or refer to
Technical Specifications
current draw under normal conditions.
For more information, download Sizing Circuit Breakers from the Chauvet website
www.chauvetlighting.com/download/.
·
Always connect the product to a protected circuit.
·
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat or dimmer.
To replace the fuse, do the following:
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the fuse holder out of the housing.
4. Remove the blown fuse from the holder.
5. Insert a fuse of the exact same type and rating.
6. Replace the fuse holder back into the slot.
7. Reconnect the product to power.
Spare Fuse
(not included)
Spare Fuse Holder
(inside safety cap)
· Disconnect the product from power before replacing the fuse.
· Always replace a blown fuse with another of the same type and rating.
A spare fuse is not included; however, the safety cap has room for one.
in this manual. The listed current rating indicates the product's average
Installed Fuse
(held by plastic clip)
Safety Cap
Page 11 of 94

3. Setup