Standalone Configuration; Automatic Mode; Automatic Programs; Sound Mode - Chauvet DJ Motion Orb Mode D'emploi

Standalone
Configuration

Automatic Mode

Automatic
Programs
Automatic
Program Speed

Sound Mode

Sound Sensitivity

Custom Color

MotionOrb User Manual Rev. 66
Standalone configurations allow the MotionOrb to operate without a DMX controller. There are a
variety of Standalone modes and they are powerful tools for making exciting looks.
Never connect a product in a Standalone mode (Auto or Sound) to a DMX chain that
includes a DMX controller. Products in Standalone mode transmit DMX signals that
interfere with the DMX signals from the controller.
Automatic mode sets the MotionOrb to run through the currently selected program at a speed
set in the Speed function.
To set the MotionOrb to Automatic mode, do the following:
1. Make sure the MotionOrb is connected to a power source and not connected to a DMX
controller.
2. Press <MENU> repeatedly until Automatic shows on the display.
3. Press <ENTER>. The MotionOrb starts operating in Automatic mode.
Program selects 1 of 30 preset color patterns and changes for the MotionOrb to go through in
Automatic mode.
1. Press <MENU> repeatedly until Program shows on the display.
2. Press <ENTER>. The currently selected program shows on the display.
3. Use <UP> or <DOWN> until the desired program shows on the display.
4. Press <ENTER> the MotionOrb™ starts operating in the newly selected program mode.
The Speed setting adjusts how fast the MotionOrb goes through an automatic program.
To adjust the speed setting, do the following:
1. Press <MENU> repeatedly until Speed shows on the display.
2. Press <ENTER> and 1–3 also shows on the display.
3. Use <UP> or <DOWN> until the desired speed shows on the display.
Sound mode sets the MotionOrb to respond to sounds and music.
To set the MotionOrb™ to Sound mode, do the following:
1. Press <MENU> repeatedly until Sound shows on the display.
2. Press <ENTER>. The MotionOrb begins responding to sounds and music.
· The MotionOrb responds only to low frequencies of music such as bass or drums.
· If the MotionOrb does not respond to sounds or music increase the sound sensitivity.
The Sound Sen setting adjusts the sensitivity of the MotionOrb microphone.
To adjust the sensitivity setting, do the following:
1. Press <MENU> repeatedly until Sound Sen and a number show on the display.
2. Use <UP> or <DOWN> until the desired sensitivity shows on the display.
Color sets all the orbs to a single color.
To set the MotionOrb to a single color, do the following:
1. Press <MENU> repeatedly until Color shows on the display.
2. Press <ENTER>. A color (Red, Green, Blue) shows in the display with 3 numbers under it
and the MotionOrb glows in the currently selected color.
3. Use <UP> or <DOWN> to adjust the color value 000–255 (0–100%).
Note: Selecting 000 turns off that color.
4. Press <ENTER> to set the color and scroll through the other colors.
4. Operation
Page 19 of 94