Configuration
(Standalone)
Sound-Active
Mode
Automatic Mode
Page 18 of 60
Set the product in one of the standalone modes to control without a DMX controller.
· Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode (Static,
Automatic, or Sound) to a DMX string connected to a DMX controller. Products in
standalone mode may transmit DMX signals that could interfere with the DMX
signals from the controller.
To enable the Sound Active mode, do the following:
1.
Press <FUNC> repeatedly until SOU0—SOU6 blinks on the display.
2.
Use <UP> or <DOWN> to select the desired Sound-Active mode.
3.
Turn the music on and adjust the sound sensitivity knob until the product starts
responding to the beat of the music.
4.
Press <ENTER> and the SOUND indicator light turns on.
The product will only respond to low frequencies of music (bass and drums).
The laser will BLACKOUT when in Sound-Active mode after 3 seconds of silence
or noise below the sensitivity setting.
To enable the Automatic mode, follow the instructions below:
1.
Press <FUNC> repeatedly until AUT0—AUT6 blinks on the display.
2.
Use <UP> or <DOWN> to select the desired automatic program.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to adjust the auto program speed, S 1 (fast) to S100 (slow).
5.
Press <ENTER> and the AUTO indicator light turns on
Swarm™ 5 FX User Manual