Configuration (Standalone); Automatic Programs; Auto-Program Speed; Sound-Active Mode - Chauvet DJ HELICOPTER Q6 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

O
PERATION

Configuration (Standalone)

Set the product in one of the standalone modes to control without a DMX controller.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.

Automatic Programs

To run the Helicopter Q6 in automatic mode, follow the instructions below:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select an automatic program, from P 1–10.
4.
Press <ENTER>.

Auto-Program Speed

To change the auto-program speed on the Helicopter Q6, do the following:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Use <UP> or <DOWN> to increase or decrease the program speed, from S 01–99.
3.
Press <ENTER>.

Sound-Active Mode

To run the Helicopter Q6 in sound-active mode, follow the instructions below:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select a sound-active program, from Sn 1–10.
4.
Press <ENTER>.
5.
Turn the sensitivity knob up until the product responds to the beat of the music.
The product will only respond to low frequencies of music (bass and drums).

Static Color Mode

To run the Helicopter Q6 on a static color, do the following:
1.
Press <MENU> repeatedly until C-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select a static color, from C 1 (red), C 2 (green), C 3 (blue), or C 4
(white).
4.
Press <ENTER>.

Rotation Mode

To control the direction and speed of the rotation when in static color mode, follow the instructions below:
1.
Press <MENU> repeatedly until Moto shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select a rotation direction, from di-L (left) or di-r (right).
4.
Press <ENTER>.
5.
Use <UP> or <DOWN> to increase or decrease the rotation speed, from S 0–99.
6.
Press <ENTER>.
Helicopter Q6 User Manual Rev. 1
Page 13 of 98

Publicité

Table des Matières
loading

Table des Matières