Setting The Offset Temperature; Restoring The Factory Settings - eQ-3 C Classic Mode D'emploi

• Use the setting wheel to select the "AER" menu item.
Confirm with OK.
•
Use the setting wheel to set the temperature and time.
•
To deactivate the function, select a time of "0".

13. Setting the offset temperature

The temperature is measured at the heating appliance it-
self, with the result that other parts of the room may be
warmer or colder than this. To allow for this, you can set
a temperature offset of ±3.5°C. If, for example, a temper-
ature of 18°C is measured somewhere within the room
instead of the 20°C set, it means that an offset of -2.0°C
needs to be configured.
• Press and hold down the menu button for more than
3 seconds.
Use the setting wheel to select the "TOF" menu item.
•
Confirm with OK.
•
• Use the setting wheel to modify the temperature.
Press the OK button to confirm.
•

14. Restoring the factory settings

You can reset the actuator to its initial state manually. This
will clear all the settings that have been made manually.
Press and hold down the menu button for more than
•
3 seconds.
Use the setting wheel to select the "RES" menu item.
•
• Confirm with OK.
"CFM" will appear on the display; press OK to confirm.
•
30