Troubleshooting (For Users) - Kunzle & Tasin BLIZZARD Mode D'emploi Et De Maintenance

LEVIGABORDI – EDGE SANDER – PONCEAUSE -
PROBLEM
Insufficient sanding depth Sanding disk worn or unsuitable
Insufficient motor speed
Motor does not start
Insufficient dust suction
MANUALE DI ISTRUZIONE – USE AND MAINTENANCE HANDBOOK – MANUEL POUR L'EMPLOI - BEDIENUNGSAINLEITUNG
BLIZZARD

TROUBLESHOOTING (for users)

CAUSE
Insufficient voltage due to:
Excessive length or inadequate
section of power cables
Poor connections
Power capacitor defective
Motor defective
Defective ok switch or power
control
Defective power capacitor
Insufficient voltage due to poor
connections
Defective motor
No power
Dust bag over 2/3 full
Suction tube blocked
Fabric filter blocked
BORDERSHLAUFMACHINE
REMEDY
Replace sanding disk
Use cables with adequate
section and length
Make proper connections
Contact an authorised K&T
distributor
Contact an authorised K&T
distributor
Contact an
distributor
Contact an
distributor
Contact an
distributor
Contact an authorised K&T
distributor
Check mains power and
connections
Replace paper dust bag
Clean suction tube
Clean filter
ED.07
Pag. 21/40
authorised K&T
authorised K&T
authorised K&T