Music Streaming; Listening To Music From An Audio; Device; Adjusting The Volume Level - Sony Bluetooth MEX-BT2600 Mode D'emploi

Music streaming

Listening to music from an audio

device

You can listen to music of an audio device on this
unit if the audio device supports A2DP
(Advanced Audio Distribution Profile) of
Bluetooth technology.
1
Turn down the volume on this unit.
2
Press (SOURCE) repeatedly until "BT
AUDIO" appears.
3
Operate the audio device to start
playback.
4
Adjust the volume on this unit.

Adjusting the volume level

The volume level is adjustable for any difference
between the unit and the Bluetooth audio device.
1 Start playback of the Bluetooth audio device at
a moderate volume.
2 Set your usual listening volume on the unit.
3 Press the select button repeatedly until "BTA"
appears, and rotate the volume control dial to
adjust the input level (–8 dB to +18 dB).

Operating an audio device with this

unit

You can perform the following operations on this
unit if the audio device supports AVRCP (Audio
Video Remote Control Profile) of Bluetooth
technology. (The operation differs depending on
the audio device.)
To Press
(6) (PAUSE)* on this unit.
Play
(6) (PAUSE)* on this unit.
Pause
Skip tracks SEEK –/+ (
each track]
* Depending on the device, it may be necessary to
press twice.
Operations other than the above should be
performed on the audio device.
Notes
• During audio device playback, information such as
track number/time, playback status, etc., of a
connected audio device is not displayed on this unit.
• Even if the source is changed on this unit, playback
of the audio device does not stop.
Tip
You can connect a cellular phone that supports A2DP
(Advanced Audio Distribution Profile) as an audio
device and listen to music.
/ ) [once for
. >
Deleting registration of all
paired devices
1
Press (OFF).
This unit is turned off.
2
If " " lights, press and hold
(BT) until "
" turns off.
3
Press and hold the select button.
4
Press the select button repeatedly
until "BT INIT" appears.
5
Press (SEEK) +.
Initializing starts.
It takes 3 seconds to cancel all registration.
Do not turn off the power while "INITIAL" is
flashing.
15