Select Cycle; Select Water Level - Maytag PAV5157AWW Guide De L'utilisateur

C
ONTROLS AT A GLANCE
Control features vary by model.
Step 1

Select cycle

Press the control dial in and turn clockwise to the desired cycle.
Pull the dial out to start the washer. You may stop the washer at
any time by simply pushing the control dial IN. Therefore, it is
possible to obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be pushed IN
(off position) when you change the setting.
Note: Do not attempt to turn the control dial counterclock-
wise. Damage to the timer will result.
PRETREAT CYCLE: Provides approxi-
mately 30 minutes of agitation and soaking
to help remove stubborn dirt and stains.
For more information see page 4.
PERMANENT PRESS FABRICS CYCLE:
Provides up to 12 minutes of agitation.
Depending on the load, select either the
Delicate/Fast or Regular/Slow wash/spin speed.
Step 2 Select end of
cycle signal
Your washer provides an adjustable end of
cycle signal from off to loud.
Step 3

Select water level

Determine the selected setting based on
clothes load size. The control allows you to
select a specific setting (select models) or
anywhere in between.
It may become necessary, due to bulky fab-
rics, to adjust the water level after agitation
begins. To adjust the water level, turn the
control to RESET and then back to the
desired setting.
NORMAL/DELICATE CYCLES: Share the same por-
tion of the control dial. For regular fabrics, select the
cycle and turn the Wash/Spin Speed dial to
Regular/Fast. For delicate loads select Delicate/Slow.
LOAD SIZE
SUPER – 3/4 – Full
LARGE – 1/2 – 3/4 Full
MEDIUM – 1/3 – 1/2 Full
MINI – 1/4 Full
REMEMBER: Items must circulate
freely for best results.
2