Installing The Booster Seat - Axkid Mate ECE R44/04 Manuel D'instructions

Installing The Booster Seat

Position the booster seat on a suitable passenger seat, ensuring it is
2
pushed back against the backrest. Place your child on the booster
seat and fasten the seat belt across your child. The lap section of
the belt should sit as far forward as possible over the hips and pass under
both armrests. Adjust the seat belt to fit your child and remove as much
slack as possible, ensuring the straps are not twisted.
Check that the shoulder belt lies across your child' s shoulder
3
properly and does not lie across their neck.
If the shoulder belt is resting against your child' s neck then the belt
clip (C) should be used to curve the shoulder belt over the child' s shoulder
giving a more secure fit.
Adjust the belt clip strap (B) so that the belt clip (C) is just able to lie
4
on the child' s shoulder and then attach the belt clip to the shoulder
belt. Check that the shoulder belt is now lying correctly across your
child' s shoulder. If the belt is still resting against your child' s neck adjust the
belt clip strap until you have a correct fit.
Note: The belt clip is permanently attached to the underside of the booster
seat and should not be removed. When not using the clip; wrap the strap
around the clip and tuck it under the booster seat side-fabric.
Never install a child restraint in a passenger seat where
an active airbag is fitted.
8