Electrical Connections - Dri-Eaz F259 Manuel Du Propriétaire

ELECTRICAL CONNECTIONS

Ace TurboDryers are designed to operate on a 115V/60 Hz elec-
trical connection. Make sure that the electrical outlet is grounded
and that all safety precautions are taken.
MAINTENANCE
Always turn off the power before performing maintenance proce-
dures. All the service procedures below are to be executed with
the unit unplugged. Perform before each use or as needed.
INSPECT ELECTRICAL SYSTEM: Inspect the electrical cord for
damage at regular intervals. Periodically, remove the housing
and inspect internal wiring for bare wires, insecure fasteners,
and discoloration. Remove and repair any damaged wiring as
needed. Failure to do so may lead to electrical shock or a fire
hazard.
CLEAN GRILLS: Clean off any accumulated lint or other mate-
rials from the protective grill cover. A buildup will reduce the air-
flow and may cause the motor to overheat and become a fire
hazard.
07-01475 D 2010-07
CLEAN EXTERIOR: Clean the housing with mild detergent and
water. Bring back the original shine with a vinyl cleaner and
polish like those used on automobile plastics.
EXTERIOR INSPECTION: Evaluate exterior components and
make sure they are properly installed. Listen to the unit for ab-
normal sounds. Repair or replace components as needed.
Periodic Maintenance (as needed)
Make sure unit is unplugged and the blade has stopped. Re-
move four screws to remove each grill cover. This will permit
access to motor and fan blade for cleaning.
CLEAN COMPONENTS: Use compressed air or a vacuum to
remove lint and dust from fan blade, motor and grill covers.
DO NOT WET MOTOR OR WIRING: To prevent damage to
electrical components, do not use a hose or pressure washer to
clean a TurboDryer. If electrical components do become wet, dry
them immediately.
MOTOR BEARINGS: The bearings on all Dri-Eaz TurboDryers
are permanently lubricated. Do not oil.
3 Dri-Eaz Products, Inc.