Dri-Pod™ Direct Flow Carpet Dryer
The Dri-Pod is a high velocity airmover that creates an aggressive 360°airflow
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
WARNING! To reduce the risk of fire or
electric shock, do not use this fan with any
solid-state speed control device.
WARNING! Unit must be grounded. Do not use with an
extension cord. Connect only to an outlet provided with a ground
fault interrupting device.
WARNING! Do not touch grills when unit is operating.
NOTICE: Keep motor dry. For indoor use only.
NOTICE: Unplug when not in use or when moving unit.
NOTICE: Do not allow children to play with or around the unit.
Be sure the unit is inaccessible to children when not attended.
NOTICE: Always operate the unit on a stable, level surface so it
cannot fall and cause injury.
WARNING! Do not alter or modify your Dri-Pod in any way. Use
only replacement parts authorized by Dri-Eaz Products, Inc.
Modifications or use of unapproved parts could create a hazard
and will void your warranty. Contact your authorized Dri-Eaz
distributor for assistance.
WARNING!
a) Do not operate any fan with a damaged cord or plug. Discard
fan or return to an authorized service facility for examination
and/or repair.
b) Do not run cord under carpeting. Do not cover cord with throw
rugs, runners, or similar coverings. Do not route cord under
furniture or appliances. Arrange cord away from traffic area and
where it will not be tripped over.
OPERATING INSTRUCTIONS
1.
Unwrap the cord and plug the unit into a standard 115V
outlet. CAUTION: Be sure switch is in the off position before
connecting unit to power outlet.
2.
Position the Dri-Pod in the center of an area to be dried.
Switch on. The Dri-Pod can dry an area approximately
10 × 10 ft. (3 × 3 m).
3.
When surface is dry to the touch, switch unit off and
reposition the unit in the next section to be dried.
4.
When finished, unplug the unit and re-wrap the cord in the
cord wrap.
07-01759D F451-115V
Owner's Manual
Model F451-115V
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA 98233
Phone: 800-932-3030 Fax: 360-757-7950 www.dri-eaz.com
across floor surfaces to accelerate drying.
Patents: http://www.LBpatents.com
Transporting and Storing
Always use the handle to load or carry the unit. Units may be
stacked for transport and storage.
When transporting in a vehicle, secure the unit carefully to
prevent sliding and damage to the unit and/or injury to vehicle
occupants.
FOR SERVICE CALL YOUR LOCAL DISTRIBUTOR or the Dri-Eaz
Service Department at 800-932-3030
PARTS IDENTIFICATION
Handle
Cord wrap
SPECIFICATIONS
Model
F451
Weight
10.6 lbs. | 4.8 kg
Dimensions
15.2 × 15.2 × 8.9 in.
(D × W × H)
38.5 × 38.5 × 22.5 cm
Amp draw
1.1 amps
Control
On/Off switch
Power
130W/115V
Cord length
10 ft. | 3 m
Fan
5 blades
Construction
Injection molded housing, wire grill
Safety
UL listed and CSA standards
Specifications are subject to change without notice. Some values
may be approximate.
1
On/Off switch
Dri-Eaz Products, Inc.