Dri-Eaz Dri-Pod F451 Manuel D'utilisation

Dri-Pod™ Direct Flow Carpet Dryer
The Dri-Pod airmover creates an aggressive, high velocity 360°airflow across floor surfaces to accelerate drying.
R E A D A N D U N D E R S T A N D B E F O R E O P E R A T I N G
ELECTRIC SHOCK HAZARD
The unit must be electrically grounded. Use only on GFCI
protected receptacles.
Connect to a properly grounded outlet only. Do not cut off the
grounding prong. Do not use with an adapter.
Do not use with extension cords.
Do not use with damaged cord or plug. If unit is not working as it
should, has been dropped, damaged, left outdoors, or exposed to
water, return it to an authorized service center for repair.
Do not leave unit unattended when plugged in. Unplug cord from
outlet when not in use or when servicing unit.
ELECTRIC SHOCK HAZARD
Keep motor and electrical parts dry.
Do not use outdoors. This unit is for indoor use only.
Do not handle plug or unit with wet hands.
Do not operate unit in standing water.
ELECTRICAL SAFETY DEVICES
Circuit breaker: If the circuit breaker detects overload or short
circuit conditions, the breaker will automatically shut off the
electrical supply. If this should occur, check the power cable
carefully for any damage and ensure it is plugged into a properly
grounded outlet. Press the Circuit Breaker Reset Switch (Fig. A)
to reestablish the electrical supply.
OPERATING INSTRUCTIONS
1. Unwrap the cord and plug the unit into a standard 115V
outlet. CAUTION: Be sure switch is in the off position before
connecting unit to power outlet.
2. Position the Dri-Pod in the center of an area to be dried.
Switch on. The Dri-Pod can dry an area approximately
10 × 10 ft. (3 × 3 m).
3. When surface is dry to the touch, switch unit off and
reposition the unit in the next section to be dried.
4. When finished, unplug the unit and re-wrap the cord in the
cord wrap.
TRANSPORTING AND STORING
Always use the handle to move or carry the unit. Units may be
stacked for transport and storage. When transporting in a vehicle,
secure the unit carefully to prevent sliding and damage to the unit
and/or injury to vehicle occupants.
07-01759F F451 (115V)
Owner's Manual
Model F451 (115V)
DRI-EAZ PRODUCTS
15180 Josh Wilson Road, Burlington, WA 98233
Live Chat: Info.Legendbrands.com |
Patents: LBpatents.com
Legendbrandsrestoration.com
PARTS IDENTIFICATION
Handle
Cord
Wrap
FOR SERVICE CALL YOUR LOCAL DISTRIBUTOR or the Legend
Brands Service Department at 800-932-3030
SPECIFICATIONS
Model F451
Weight 10.5 lbs. | 4.8 kg
Dimensions 15.2 × 15.2 × 9.3 in.
(D × W × H) 38.5 × 38.5 × 22.6 cm
Amp draw 1.0 amps
Control On/Off switch, circuit breaker, receptacle
Power 115W/115V
Cord length 10 ft. | 3 m
Fan
5 blades
Construction Injection molded housing, wire grill
Safety
UL listed
Specifications are subject to change without notice. Some values
may be approximate.
1
On/Off
Switch
Circuit
Breaker
Reset
Switch
Convenience
Receptacle
Legend Brands, Inc.