Demolition Of The Slicer - Van Berkel International HOME LINE Serie Manuel D'instructions

POSE. VAN BERKEL SHALL
NOT BE LIABLE FOR ANY
INCIDENTAL OR CONSE-
QUIENTIAL DAMAGES TO
BUYER OR ANY THIRD
PARTY, INCLUDING, WITH-
OUT LIMITATION, LOSS OF
PROPERTY, PERSONAL IN-
JURY, OR STATUTORY OR
EXEMPLARY DAMAGES,
WHETHER IN NEGLICENCE,
WARRANTY, STRICT LIABIL-
ITY OR OTHERWISE.
This warranty is not trans-
ferable and is limited to the
first and original buyer from
a Van Berkel Authorized
Channel of Distribution. No
warranty is given to subse-
quent transferees.
THE FOREGOING WAR-
RANTY PROVISIONS ARE
A COMPLETE AND EXCLU-
SIVE STATEMENT OF THE
WARRANTY BETWEEN THE
BUYER AND SELLER. VAN
BERKEL NEITHER ASSUMES
NOR AUTHORIZES ANY
PERSONS TO ASSUME ANY
OTHER OBLIGATION OR
LIABILITY IN CONNECTION
Troubleshooting
PROBLEM
The machine does not start when
the on button is pressed
When the start button is pressed,
the machine starts but
the operation indicator light
does not switch on
When the stop button is pressed,
the machine does not stop
Excessive resistance to
sliding component movement
(product holder, carriage).
WITH SAID EQUIPMENT.
Example of items not cov-
ered under warranty, but not
limited to just these items:
1. acts of God, fire, water
damage, burglary, accident,
theft, vandalism;
2. freight damage;
3. improper installation or
alteration of equipment;
4. use of generic or after-
market parts;
5. repairs made by anyone
other than a Van Berkel des-
ignated servicer;
6. periodic maintenance of
equipment including but not
limited to lubrication and
sharpening, and other adjust-
ments required due to instal-
lation set-up or normal wear;
7. replacement
blades, knives, stones, knobs,
accessories, and miscellane-
ous expendable supply items;
8. cleaning of equipment;
9. misuse or abuse.
DEMOLITION OF
THE SLICER
PROBABLE CAUSE
No power or defective
control circuit
Defective indicator light
Defective control circuit Immediately stop the machine by
Sliding guide lubrication
not performed
periodically
The machines are com-
prised of:
- aluminium/magnesium al-
loy structure;
- inserts and various com-
ponents and stainless steel;
- electrical parts and elec-
trical cables;
- electric motor;
- plastic material, etc.
If dismantling and demoli-
tion are entrusted to third
parties, use only companies
authorised for disposal of
the above-mentioned ma-
terials. Packaging materi-
als and appliances contain
recyclable materials. Your
appliance contains valuable
materials that can be recov-
ered or can be recyclable.
of worn Separation of the remaining
waste materials into dif-
ferent types facilitates the
recycling of valuable raw
materials. Leave the appli-
ances at a collection point.
You can obtain information
on disposal from your local
authorities.
REMEDY
Check if the plug has been inserted
correctly. Contact a Service Centre if
the problem persists
Do not use the machine with the
indicator light off. Contact a service
centre
pulling the plug out of the socket and
immediately contact a service centre
Perform periodic
lubrication
9