Important Safety Instructions - Hedson IRT UV SMARTCURE Manuel D'instructions

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical equipment, basic precautions
should always be followed, including the following:
Read all instructions before using IRT UV SmartCure.
WARNING!
UV radiation can cause personal injury and
property damage!
UV emitted from this product. Skin or eye
injury may occur. Avoid exposure of eyes
and skin to unshielded lamp.
Summary of results from RISE, Research Institutes of
Sweden AB
Depending on the distance from the UV curing device,
the limit value according to AFS 2009:7 index b. (UVA
eye) for one working day (8 h) is reached after one or
a few minutes at close distances (0.5–1 m). At longer
distances than about 5 m, the acceptable exposure
time is an hour or more. The acceptable exposure times
according to index a. in AFS 2009:7 (UVA, UVB and UVC,
skin and eye) are more than 50 times longer than for
index b. (UVA eye).
To reduce risk of injury or property damage from UV
radiation, read, understand, and follow the following
safety instructions. In addition, make certain that anyone
else that uses this curing equipment follows these safety
instructions as well.
• Always wear eye protection. Failure to this may result
in long term injury to the eyes.
• Wear protective clothing. Hands, face and other
parts of the body shall not be exposed to heat and
radiation. Do not stay in front of the lamp cassettes
during curing without safety equipment.
• If a person works around UV radiation while on
medications, the medication should be checked to
see if it would make the person more photosensitive.
• Do not look directly at the light source.
715098 rev 3
WARNING!
To reduce the risk of fire, electric shock or
injury:
• Do not allow to be used as a toy.
• Use only as described in this manual. Use only
manufacturer's recommended attachments.
• Do not use the battery charger with damaged cord
or plug. If equipment is not working as it should, has
been dropped, damaged, left outdoors or dropped
into water, return it to a service center.
• Do not pull or carry the battery charger by cord, use
cord as a handle, close a door on cord or pull cord
around sharp edges or corners. Keep cord away from
heated surfaces.
• Do not unplug the battery charger by pulling on cord.
To unplug, grasp the plug, not the cord.
• Do not handle plug or equipment with wet hands.
• Do not store, prepare or use solvent-containing
materials within a 5 m/16 feet radius of the curing
device.
• Flammable materials should not be placed close to a
curing device in use.
• Never direct the curing device towards highly
combustible materials.
• The curing device must not be exposed to paint fog,
sanding dust or solvents due to fire and explosion risk.
Furthermore, the lifetime of the appliance will also be
reduced.
• The battery charger is operated by highly dangerous
electrical voltage.
• This product should only be used with the glass intact.
• As appropriate measures; always wear eye protection
during work in areas exposed to UV radiation and
always work in a well-ventilated environment.
• The curing device user must adhere to these
operating instructions. This appliance is not intended
for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Do not use in wet or moisture conditions.
• Do not disassemble the battery.
• Use IRT UV SmartCure only with original battery.
• In damaged or leaking battery, dangerous vapors
may occur. Get fresh air. In case of inconvenience, get
medical advice.
• Protect battery terminals against conductive subjects
to prevent short circuit.
• Protect battery from high temperature.
• Use the battery only with IRT UV SmartCure to prevent
overload.
EN 3 3