Setting To Work - Connection To The Power Supply; Extensions; Wet And Dry Applications; Vacuuming Of Liquids - Nilfisk VHS110N1 CR Manuel D'instructions

Setting to work - connection to the power
supply
WARNING!
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
Before plugging the vacuum cleaner into the
■
electrical mains, make sure that the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Plug the vacuum cleaner into a plug with a
correctly installed ground contact/connection.
■ Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the connection
cords must be protected against splashed water.
Make sure that connections to the electrical
■
mains and plug are correct.
■ Use the vacuum cleaners only when the cords
that connect to the electrical mains are in perfect
condition (damaged cords could lead to electric
shocks!).
■ Regularly check that the electric cord does not
show signs of damage, excessive wear, cracks or
aging.
WARNING!
When the vacuum cleaner is operating, do not:
■ Crush, pull, damage or tread on the cord that
connects to the electrical mains.
■ Only disconnect the cord from the electrical
mains by removing the plug (do not pull the
cord).
■ Only replace the electric power cord with one of
the same type as the original: SJT. The same rule
applies if an extension is used.
■ The cord must be replaced by the manufacturer's
Service Center staff or by equivalent qualified
personnel.

Extensions

If an extension cord is used, make sure it is fit for the power
draw and protection degree of the vacuum cleaner.
Minimum section of extension cords: 16 AWG
Maximum length = 20 m
Cord = SJT
WARNING!
Sockets, plugs, connectors and installation of the
extension cord must maintain the IP protection degree
of the vacuum cleaner, as indicated on the data plate.
WARNING!
Never spray water on the vacuum cleaner: this could
be dangerous for persons exposed and could short
circuit the power supply.
04/2016
WARNING!
The vacuum cleaner's power plug must be protected
by a differential circuit-breaker with surge current
limitation that shuts off the power supply when the
current discharged to the ground exceeds 30 mA for
30 msec. or an equivalent protection circuit.

Wet and dry applications

The supplied filters and the bag (if applicable) must be
installed correctly.
WARNING!
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
WARNING!
If the version for liquids is used:
■ If foam forms, turn off the vacuum cleaner
immediately and empty the container.
N.B.: Switch off the vacuum cleaner immediately if
foam or liquid leaks out.
■ Regularly clean the liquid level limiting device
and check to make sure that there are no signs of
damage.
N.B.: dirty liquid vacuumed up by the vacuum cleaner
must be considered conductive.
WARNING!
When vacuuming a mix of water and air, take care to
avoid overloading the motor of the vacuum unit.

Vacuuming of liquids

WARNING!
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
WARNING!
■ Before vacuuming, check that the float is present.
■ If foam forms, turn off the vacuum cleaner
immediately and empty the container.
Warning: switch off the vacuum cleaner
■
immediately if foam or liquid leaks out.
■ Warning: the dirty liquid collected by the vacuum
cleaner must be considered conductive.
WARNING!
Do not use the vacuum cleaner without the float!
If it's used without the float, the vacuum cleaner may
be seriously damaged.
5
VHS110N1 CR
[ NOTE ]
US
C424