Technical Specifications; Correct Usage; Parts Of The Tool - Rupes HR81M Mode D'emploi

TECHNICAL SPECIFICATIONS

TYPE
Voltage (VDC)
RPM
Battery life (min)
Charging time (min)
Electronic speed control
Overcurrent protection
Soft start
LED indication
Dimensions (mm)
Weight (g)
* The value is referred to a use of the battery pack 9HB120LT, fully charged with a charger 9HC120LT and normal
use with a Rupes polishers HR81M/HR81ML and functional unit orbit 12mm and Ø30mm buffer pad.
** measured without a functional unit, battery pack, and power supply
WARNINGS
The safety and accident prevention instructions are reported in the "SAFETY INSTRUCTION" booklet which is
an integral part of these documents. This operating instructions manual indicates the additional information
required for the specifi c use of the tool.

CORRECT USAGE

CAUTION: DO NOT PUSH SHAFT LOCKING BUTTON (6) DURING USE! PUSH THE BUTTON ONLY WHEN
THE SWITCH (2) IS IN OFF POSITION.
This tool is designed to be used as a polisher. Read all the warnings, instructions, indications provided on
drawings and specifi cations supplied with this tool. Failure to comply with all the instructions provided below
may cause electrical shocks, fi re and/or serious injuries.
This tool is not intended to be used for smoothing, metal brushing and cutting operations. The use of this
tool for unintended applications may cause hazards and injuries to people.
The tool must be used with accessories that have been specifi cally designed or recommended by the
manufacturer. The fi xing of the accessory to the tool does not guarantee a safe operation.
The rated speed of the accessories must be at least equivalent to the maximum speed specifi ed on the tool.
Using the accessories at speeds above the rated one, may cause them to break or thrown into the air.
The external diameter and thickness of the accessories must match the specifi cations of the tool.
Accessories with incorrect dimensions cannot be adequately protected or controlled.
The confi guration of accessories must match the tool. The use of accessories that cannot be perfectly fi tted on
the tool may result in imbalance, excessive vibrations and in the impossibility of controlling the tool.
Do not use damaged accessories. Before use, inspect all the accessories. Inspect the supporting pads and
verify there are no cracks, tears or excessive wear. If the tool or accessory has fallen, verify that it is not
damaged or install a new accessory. After inspecting or installing an accessory, test the operation of the
tool at maximum speed and without load for one minute, keeping at a safety distance.
If the accessories are damaged, they will break during this test.

PARTS OF THE TOOL

1 - Identifi cation plate
2 - ON/OFF / speed regulation Knob
3 - Buffer pad (not supplied)
4 - Velcro faced disc pad
5 - Motor ventilation slots
6 - Shaft locking button
7 - ON/OFF switch lever
HR81M
10.8/12
2000-5000
~30*
~20
•
•
•
•
287x70x47**
470**
8 - Battery pack 10,8V cod 9HB120LT
9 - Battery level LED
10 - Power supply 9HP120LT (optional)
11 - Functional unit shaft: Red color orbit 12,
Blue color orbit 3,
Green color rotary version
12 - Extention shaft 291.390
HR81ML
10.8/12
2000-5000
~30*
~20
•
•
•
•
332x70x47**
520**
7