Application And Operation - IDC Mill 5X Mode D'emploi

A P P L I C A T I O N A N D O P E R A T I O N
For wet processing:
▷ Insert the swarf sieve with the wide side facing
E N
toward the rear.
Without the swarf sieve, chips/swarf will be
flushed into the container. The filter bag will fill
up more quickly.
The swarf sieve is included in the delivery
scope of the supply unit. It can remain
inserted in the machine during dry
processing.
▷ Shut the door of the milling machine.
▷ Switch the milling machine on via the main
switch.
▷ Switch the PC on.
▷ Start the milling machine software.
When the software is started, a machine initiali-
sation takes place.
If the milling machine is not detected:
▷ Restart the PC.
After re-positioning the milling machine, it
is necessary to check the system axes.
▷ For this, observe the instructions for
milling the test bodies.
52
6

Application and Operation

WARNING:
Danger from shavings/chips or tool fragments
being thrown from the machine!
▷ Make sure that the door of the milling machine
is always closed during processing!
NOTE:
Insufficient milling results and increased wear
when dry processing!
▷ Do not operate the milling machine without
extraction!
NOTE:
Insufficient milling/grinding results and
increased wear when wet processing!
▷ Do not operate the milling machine without
supply unit!