Bluetooth Operation - Tivoli Audio MUSIC SYSTEM THREE+ Manuel Du Propriétaire

Bluetooth Operation

Prior to pairing, verify your device supports Bluetooth 2.1+EDR A2DP and your device is
not connected to any other Bluetooth product. Devices may pair differently. Below is a
general guide.
1. Press the Music System Three+'s front panel Bluetooth button or change the source
to Bluetooth. This will power on the Bluetooth. Turn the volume up about ¼ to start.
Also turn up the volume on the source device (the device you are streaming from).
2. Turn on the Bluetooth wireless technology on your enabled device.
3. Select "Tivoli Bluetooth (Not Paired)" when it appears on your device's screen to
initiate searching. Some devices may prompt you for a PIN. If so, enter "0000". "Tivoli
Bluetooth" will change from "Not Paired" to "Connected".
4. You will hear a ring tone from the Music System Three+ confirming connection and you
can begin playing your music files wirelessly. Adjust the volume level on your device.
You should not have to pair your device again. Depending on your device, you may
need to make multiple attempts at Pairing and/or Connecting to the Music System
Three+, but please give your device adequate time to Pair or Connect before
repeating the process.
Pairing A Bluetooth Wireless Technology Enabled
iPhone/iPod Touch/iPad
1. Press the Music System Three+'s front panel Bluetooth button or change the source
to Bluetooth. This will power on the Bluetooth. Turn the volume up about ¼ to start.
Also turn up the volume on the source device (the device you are streaming from).
2. Select "Settings" (depending on software version).
3. Select "General".
4. Select "Bluetooth".
5. Switch Bluetooth "On" to initiate searching.
6. Select "Tivoli Bluetooth (Not Paired)" when it appears on the display. If you are
prompted to enter a PIN, enter "0000". "Tivoli Bluetooth" will change from "Not Paired"
to "Connected".
7. You will hear a ring tone from the Music System Three+ and you can begin playing your
music files wirelessly. Adjust the volume level on your device. You should not have to pair
your iPhone/iPod/iPad again.
The volume output level of music files varies. If you prefer an even higher output level, check
the settings in your iPhone/iPod touch/iPad: Set the EQ Off, the SoundCheck Off, and the
Volume limit Off.
If you encounter a problem Pairing, press the small arrow to the right of "Tivoli Bluetooth" on
your iPhone/iPod touch/iPad display and select "Forget this Device", then repeat the Pairing
process. Depending on your device, you may need to make multiple attempts at Pairing
and/or Connecting to the Music System Three+, but please give your device adequate
time to Pair or Connect before repeating the process.
When streaming music, you can press the blue arrow to the right of the next track button
>>/ on the iPhone/iPod touch/iPad display to alternate between the iPhone/iPod/iPad and
Bluetooth.
15 – ENGLISH