Manual Tune; Digital Radio / Fm / Auxiliary Menus - Tivoli Audio MUSIC SYSTEM THREE+ Manuel Du Propriétaire

11. MENU/SELECT: Press and hold to enter the main menu within each source mode
and press briefly to select items within the menu. For more, see the sections below
marked "Menu" for DAB, FM, and Auxiliary Menus.
12. STAGE: Press to change the Wide/Stereo/Mono setting. The letter "M' will show on
the display when in the Mono setting. The Music System Three+ will always default
to the Wide setting each time it is powered on regardless of the last setting used.
Note: only FM mode can be changed to Mono. Press the Info button on the remote to
see which stage mode the Music System Three+ is in.
13. BACK: Press to go back to the previous menu page.
Note: With the radio in standby, briefly press the p arrow button on the remote control
twice to turn the display off. While the display is off, briefly press the p arrow button once
to turn the display on for 10 seconds. Briefly press the p arrow button on the remote two
more times to turn the display back on.
Digital Radio (DAB/DAB+) Menu
In DAB mode, press and hold the Menu button on the remote to enter the main menu.
Use the pq buttons and the Select button to change the items within the menu. Use the
Back button to navigate back.
An asterisk (*) indicates the shown menu item is currently set.
Note: Upon entering Digital radio mode, if the Station List is empty, an auto scan will initiate.
Note: The Main Menu will time out if no action is taken after nine seconds.
1. AUTO SCAN: Searches the entire frequency range. If you move the Music System
Three+ to another location, you must perform a new scan so the radio will find stations
in the new location. To cancel the auto scan, press the Back button on the remote.
2. TIVOLI EQ: Press the Select button and use pq and Select buttons to adjust the Bass
and Treble. The adjusted values will be shown in "User EQ". Press the Select button
to turn Loudness On or Off. Turning Loudness on when listening at low volume levels
is recommended since it boosts high and low frequencies resulting in a more natural
sound. Use the pq and Select buttons to activate any one of the pre-set EQ settings.
Selecting a preset EQ will over-ride any adjustment made to the Bass and Treble
settings, but Loudness will be unaffected. The "Flat" EQ restores the audio settings
to the factory defaults, meaning Bass and Treble will be re-set to zero. The "Flat" EQ
also restores Loudness Off. However, if the Bass and Treble had been adjusted, those
settings will still be shown in "User EQ". Simply selecting "User EQ" will reactivate the
Bass and Treble settings. In the EQ menu page, the numbers to the right hand side
indicate the bass and treble settings.
3. MANUAL TUNE: Press the pq buttons on the remote to manually tune specific DAB/
DAB+ frequencies. Press the Select button on the remote when the desired frequency
is found, then press the left arrow (back) button on the remote until the station tunes.
4. DRC: Dynamic Range Control allows you change the sound level of stations to make
quiet passages louder to compensate for a noisy environment, or when listening at a
low volume level.
5. SETTINGS (A-F):
A. ALARM: See "How to Change Alarm Settings and Set the Alarm Via the Main Menu."
11 – ENGLISH