Storage; Troubleshooting - SilverCrest SGR 150 C1 Mode D'emploi Et Consignes De Sécurité

Electric food grater SGR 150 C1

Clean the electric food grater (1) with a damp cloth. You can apply a mild detergent to the
cloth to remove stubborn dirt. Ensure that you remove all remaining detergent with a wet cloth.

The 5 cylinders (4, 5, 6, 7, 10), the storage compartment (8), the storage compartment cover
(3), the feed chute (11), and the pusher (12) are suitable for cleaning in a dishwasher.
Alternatively, you can clean these parts with warm water and a mild detergent. After washing,
rinse the parts with clear water. Make sure that all parts are completely dry the next time you
use them.

You can now reattach the cleaned parts to the electric food grater (1) and store cleaned
cylinders (4, 5, 6, 7, 10) in the storage compartment (8).
Please note that some foods, for example, carrots or red cabbage, contain natural dyes. The plastic
parts of the food grater (1) and the accessories may be discoloured by these dyes. These
discolourations do not constitute defects.

8.4. Storage

If you will not be using the electric food grater (1) for a prolonged period, store it in a dry and
clean location.

Clean the electric food grater (1) and all accessories as described in the last section.

Store the 5 cylinders (4, 5, 6, 7, 10) in the storage compartment (8).

Insert the mains cable so far into the mains cable duct that only the mains plug can be seen.

9. Troubleshooting

The electric food grater (1) is not working.

The mains plug is not inserted in the socket. Insert the mains plug into a mains socket.

The socket is defective. Try plugging the device into another socket which you know is definitely
working.

The electric food grater (1) is defective. Contact the Service Team.
One of the cylinders (4, 5, 6, 7, 10) cannot be detached.
Always detach the entire feed chute (11) to insert or remove a cylinder (4, 5, 6, 7, 10). Also note
the following image for this purpose on page 74.
78 - English