Warnings During And After Charging - CAMPAGNOLA Speedy Manuel D'utilisation Et D'entretien

Each recharge connector (7) has a corresponding indicator on the battery charger.
The batteries are charged in sequence, the one after the other, not simultaneously.
Charge with 3 batteries: Picture 1 = Recharge in progress
Picture 2 = Fully charged
Important: When two or three batteries are connected to the battery charger, they will be charged in sequence, starting
from no. 1, then no. 2 and at the end no. 3. The LED light becomes red during the recharge, green when recharge is over.
As soon as the first battery is charged up (green LED light), the recharge of the second battery will start, then it will start
the recharge of the third one, if they are all connected to the battery charger.
During long periods of inactivity of the shear, it is recommended to charge the battery every 3 months, in order
not to compromise its lifespan.
Use only the charger supplied with the shear. A different one with other specifications could cause fires.
4.2.1

Warnings during and after charging

• While recharging, it is normal that the charger and the battery become warm.
• To make a battery reach its maximum capacity, about 5 charging and discharging cycles are necessary if it is a new
battery or if it has not been used for a long period.
• Do not charge the battery at a room temperature below 0°C (32°F) or above 45°C (113°F).
• Do not recharge a previously charged battery after few minutes of use, in order not to reduce its performance
• Do not use a damaged battery.
• Do not disassemble either the battery or the battery charger.
• When the battery is not assembled on the shear, keep it away from conductive metal objects, in order to avoid short
circuit risks.
• Do not cause a short circuit of the battery.
• Do not store the battery near heat sources, indoors or in a potentially explosive atmosphere. The battery could explode
or generate fire.
• Do not charge the battery in damp rooms or outdoors.
• Do not use or charge the battery close to heat sources or in the direct sunlight.
• When the battery charge decreases, the shear cutting performance decreases as well
• Do not leave the battery in the rain and store it in a dry place.
Page 28
Use and maintenance manual – Translation of
original Instruction. : 04 date 16/09/2021