Dettson AMP1-IE2 Guide D'installation Et Manuel Du Propriétaire page 45

4. Remove cover from control box and disconnect
the thermostat and power wires from the board.
5. Slide the blower forward on the rails toward the
front of the unit.
6. Reverse the above steps to reinstall the blower.
(Refer to wiring diagram figures # 6.1 to 6.8 of this
instruction or the diagram located on the inside of
the blower door to properly rewire the unit.)
14
CAUTION
Be sure the blower is adequately supported
when sliding out of the mounting rails,
especially in the horizontal or counterflow
positions, in order to prevent dropping the
blower and injuring yourself or damaging the
blower!