Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.1.1
7.1.1
Switch on the device
Switch on the device
Once connected to the correct supply voltage, the device starts and is operational. The LED
Once connected to the correct supply voltage, the device starts and is operational. The LED
display indicates the status.
display indicates the status.
To operate via the app , the Bluetooth® LE signal on the smartphone or tablet must be
switched on.
7.1.2
LED display
1.
Download and install App.
LED messages signal the status of the device and sensor.
2.
Start App.
LED behavior
3.
Select the device from the displayed livelist. All available devices are displayed.
Green
4.
Enter username -> admin
Flashes quickly
5.
Enter initial password -> instrument serial number
Green
Flashes twice
6.
After the first login it is recommended to change your username and password.
7.1.2
LED display
Green
Flashes slowly
LED messages signal the status of the device and sensor.
Green
Flashes quickly three times
LED behavior
Green
Flashes quickly
Green
Flashes twice
Red
Flashes quickly
Green
Red, green
Flashes slowly
Three red flashes alternating
with three green flashes
Green
Flashes quickly three times
Red
Flashes quickly
Red, green
Three red flashes alternating
with three green flashes
22
22
Status
Everything OK
Device starting up
Everything OK
Read out Memosens sensor information from sensor to transmitter (sensor type,
calibration data, etc.)
Everything OK
Sensor and device OK and functioning correctly.
Everything OK
Measured value at PLC in automatic HOLD.
Status
If the "Sensor replacement alarm delay" is exceeded, the device transmits a signal on
Everything OK
alarm.
Device starting up
The automatic hold is set to 30 seconds but can be configured to suit the customer's
needs.
Everything OK
Read out Memosens sensor information from sensor to transmitter (sensor type,
Failure of device or sensor Fault
calibration data, etc.)
state as per NAMUR NE107
Everything OK
Squawk
Sensor and device OK and functioning correctly.
Squawk is signaled briefly while the connection is established. This makes it possible to
locate the device more quickly, e. g. when several devices are installed, you can see
Everything OK
which one the connection is established with.
Measured value at PLC in automatic HOLD.
If the "Sensor replacement alarm delay" is exceeded, the device transmits a signal on
alarm.
The automatic hold is set to 30 seconds but can be configured to suit the customer's
needs.
Failure of device or sensor Fault
state as per NAMUR NE107
Squawk
Squawk is signaled briefly while the connection is established. Squawk can also be
activated via the app. This makes it possible to locate the device more quickly, e. g. when
several devices are installed, you can see which one the connection is established with.
Publicité
Chapitres
Table des Matières
