Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Electromagnetic compatibility
Electromagnetic compatibility
• The product has been tested for electromagnetic compatibility in accordance with the
• The product has been tested for electromagnetic compatibility in accordance with the
applicable European standards for industrial applications.
applicable European standards for industrial applications.
• The electromagnetic compatibility indicated applies only to a product that has been
• The electromagnetic compatibility indicated applies only to a product that has been
connected in accordance with these Operating Instructions.
connected in accordance with these Operating Instructions.
2.4
2.4
Operational safety
Operational safety
Before commissioning the entire measuring point:
Before commissioning the entire measuring point:
1.
1.
Verify that all connections are correct.
Verify that all connections are correct.
2.
2.
Ensure that electrical cables and hose connections are undamaged.
Ensure that electrical cables and hose connections are undamaged.
3.
3.
Do not operate damaged products, and protect them against unintentional operation.
Do not operate damaged products, and protect them against unintentional operation.
4.
4.
Label damaged products as defective.
Label damaged products as defective.
During operation:
During operation:
‣
‣
If faults cannot be rectified:
If faults cannot be rectified:
products must be taken out of service and protected against unintentional operation.
products must be taken out of service and protected against unintentional operation.
CAUTION
CAUTION
Cleaning not switched off during calibration or maintenance activities
Cleaning not switched off during calibration or maintenance activities
Risk of injury due to medium or cleaning agent!
Risk of injury due to medium or cleaning agent!
‣
‣
If a cleaning system is connected, switch it off before removing a sensor from the medium.
If a cleaning system is connected, switch it off before removing a sensor from the medium.
‣
‣
If you wish to check the cleaning function and have therefore not switched off the cleaning
If you wish to check the cleaning function and have therefore not switched off the cleaning
system, wear protective clothing, goggles and gloves or take other appropriate measures.
system, wear protective clothing, goggles and gloves or take other appropriate measures.
2.5
2.5
Product safety
Product safety
2.5.1
2.5.1
State of the art
State of the art
The product is designed to meet state-of-the-art safety requirements, has been tested, and
The product is designed to meet state-of-the-art safety requirements, has been tested, and
left the factory in a condition in which it is safe to operate. The relevant regulations and
left the factory in a condition in which it is safe to operate. The relevant regulations and
European standards have been observed.
European standards have been observed.
16
16
Publicité
Chapitres
Table des Matières
