Télécharger Imprimer la page

Icom IC-F52D Instructions page 3

Publicité

Les langues disponibles

Les langues disponibles

FCC INFORMATION
• FOR CLASS A UNINTENTIONAL RADIATORS:
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to
correct the interference at his own expense.
CAUTION: Changes or modifi cations to this transceiver,
not expressly approved by Icom Inc., could void
your authority to operate this transceiver under FCC
regulations.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the condition that this device does
not cause harmful interference.
RECOMMENDATION
CLEAN THE TRANSCEIVER THOROUGHLY WITH
FRESH WATER after exposure to saltwater, and dry
it before operating. Otherwise, the transceiver's keys,
switches and controllers may become unusable, due to salt
crystallization, and/or the charging terminals of the battery
pack may rust.
NOTE: If the transceiver's waterproof protection appears
defective, carefully clean it with a soft, wet (fresh water)
cloth, then, dry it before operating.
The transceiver may lose its waterproof protection if the
case, jack cap, or connector cover is cracked or broken, or
the transceiver has been dropped.
VOICE CODING TECHNOLOGY
The AMBE+2™ voice coding Technology embodied in this
product is protected by intellectual property rights including
patent rights, copyrights and trade secrets of Digital Voice
Systems, Inc. This voice coding Technology is licensed
solely for use within this Communications Equipment.
The user of this Technology is explicitly prohibited from
attempting to extract, remove, decompile, reverse engineer,
or disassemble the Object Code, or in any other way
convert the Object Code into a human-readable form. U.S.
Patent Nos.
#5,870,405, #5,826,222, #5,754,974, #5,701,390,
#5,715,365, #5,649,050, #5,630,011, #5,581,656,
#5,517,511, #5,491,772, #5,247,579, #5,226,084 and
#5,195,166.
Icom, Icom Inc. and the Icom logo are registered trademarks
of Icom Incorporated (Japan) in Japan, the United States, the
United Kingdom, Germany, France, Spain, Russia, Australia, New
Zealand, and/or other countries.
AMBE+2 is a trademark and property of Digital Voice Systems Inc.
All other products or brands are registered trademarks or
trademarks of their respective holders.
COUNTRY CODE LIST
ISO 3166-1
Country
Codes
Country
1
Austria
AT
18
Liechtenstein
2
Belgium
BE
19
Lithuania
3
Bulgaria
20
Luxembourg
BG
4
21
Malta
Croatia
HR
5
22
Netherlands
Czech Republic
CZ
23
Norway
6
Cyprus
CY
24
Poland
7
Denmark
DK
25
Portugal
8
Estonia
EE
26
Romania
9
Finland
FI
27
Slovakia
10
France
FR
28
Slovenia
11
Germany
DE
29
Spain
12
Greece
GR
30
Sweden
13
Hungary
HU
31
Switzerland
14
Iceland
IS
32
Turkey
15
Ireland
IE
33
United Kingdom
16
Italy
IT
17
Latvia
LV
< Intended Country of Use >
AT
BE
CY
CZ
DK
EE
FI
FR
DE
GR
HU
IE
IT
LV
LT
LU
MT
NL
PL
PT
SK
SI
ES
SE
GB
IS
LI
NO
CH
BG
RO
TR
HR
- 4 -
VHF/UHF DIGITAL TRANSCEIVERS
Codes
Iç-F52D
LI
LT
Iç-F62D
LU
MT
NL
NO
PL
PT
RO
SK
EXPLICIT DEFINITIONS
SI
ES
SE
WORD
CH
TR
Personal death, serious injury or an
GB
RDANGER!
explosion may occur.
Personal injury, fi re hazard or electric
RWARNING!
shock may occur.
CAUTION
Equipment damage may occur.
If disregarded, inconvenience only. No risk
NOTE
of personal injury, fi re or electric shock.
R DANGER! NEVER short terminals of the battery pack.
This may damage not only the battery pack, but also the
transceiver.
R DANGER! NEVER operate the transceiver near
unshielded electrical blasting caps or in an explosive
atmosphere.
R DANGER! Use and charge only specifi ed Icom battery
packs with Icom transceivers or Icom chargers. Only
Icom battery packs are tested and approved for use with
Icom transceivers or charged with Icom chargers. Using
thirdparty or counterfeit battery packs or chargers may
cause smoke, fi re, or cause the battery to burst.
R WARNING! NEVER operate the transceiver with a
headset or other audio accessories at high volume levels.
The continuous high volume operation may cause a ringing
in your ears. If you experience the ringing, reduce the
volume level or discontinue use.
R WARNING! NEVER operate the transceiver while driving
a vehicle. Safe driving requires your full attention—anything
less may result in an accident.
CAUTION: NEVER use harsh solvents such as Benzine
or alcohol when cleaning, because they will damage the
transceiver surfaces.
CAUTION: NEVER carry the transceiver by holding the
antenna.
CAUTION: CONFIRM the fl exible antenna, battery pack
and jack cover are securely attached to the transceiver,
and that the antenna and battery pack are dry before
attachment. Exposing the inside of the transceiver to dust or
water will result in serious damage to the transceiver.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
PRECAUTIONS
Thank you for choosing this Icom product.
READ ALL PRECAUTIONS carefully and completely
before using this product.
DISPOSAL
The crossed-out wheeled-bin symbol on your
DEFINITION
product, literature, or packaging reminds you
that in the European Union, all electrical and
electronic products, batteries, and
accumulators (rechargeable batteries) must be
taken to designated collection locations at the
end of their working life. Do not dispose of these products
as unsorted municipal waste. Dispose of them according to
the laws in your area.
PRECAUTIONS
DO NOT use or place the transceiver in direct sunlight or
in places with temperatures below –30°C (–22°F) or above
+60°C (+140°F). The basic operations of the transceiver
are guaranteed within the specifi ed operating temperature
range. However, the Liquid Crystal Display may not operate
correctly, or show an indication in the case of long hours of
operation, or after being placed in extremely cold areas.
DO NOT modify the transceiver. The specifi cations may
change and then the transceiver may not comply with
the requirements of required regulations. The transceiver
warranty does not cover any problems caused by
unauthorized modifi cation.
BE CAREFUL! The trasceiver may become hot when
operating it continuously for long periods of time. This may
damage the transceiver.
BE CAREFUL! The transceiver meets IP68 requirements
for dust-tight and waterproof protection. However, once the
transceiver has been dropped, dust-tight and waterproof
protection cannot be guaranteed because of possible
damage to the transceiver's case or the waterproof seal.
Even when the transceiver power is OFF, a slight current
still fl ows in the circuits. Remove the battery pack from the
transceiver when not using it for a long time. Otherwise, the
installed battery pack will become exhausted, and will need
to be recharged or replaced.
ALWAYS turn OFF the transceiver power before connecting
any external devices.
- 1 -
Printed in Japan
© 2017 Icom Inc.

Publicité

loading

Ce manuel est également adapté pour:

Ic-f62d