Troubleshooting - TechniSat DIGITRADIO CD 2GO Mode D'emploi

Clean the housing using a soft, damp cloth. Do not use spirit,
thinners, etc.; you could damage the surface of the device.
Only clean the display with a soft, cotton cloth. If required, use a
cotton cloth with small amounts of non-alkaline, diluted, water-
based or alcohol-based soap solution.
Gently clean the surface using the cotton cloth.

10 Troubleshooting

If the device does not operate as intended, check the following table for
information.
Symptom
The device cannot
be switched on.
No sound can be
heard.
The display does
not switch on.
Poor reception via
DAB+/FM.
The device cannot
be operated.
82
Possible cause/remedy
The device is not being supplied with power.
Connect the mains supply correctly, or insert
new batteries.
Increase the volume.
Disconnect the device from the power supply
and then reconnect it.
Change the location if necessary.
Disconnect the device from the power supply
and then reconnect it.