b. For installation with 3-point-belt and ISOFIX attachments
47
1
2
1. Installation with ISOFIX attachments is show as
2. Place the child in the child restraint and check whether the shoulder belt
guides are at proper height.
3. Installation with 3-point-belt is show as
4. Correctly assembled 3-point-belt and ISOFIX attachments is shown as
!
Make sure that both ISOFIX attachments connectors are securely attached
to their ISOFIX attachments anchor points. The colors of the indicators on
both ISOFIX attachments connectors should be completely green.
!
Check to make sure the child restraint is securely installed by pulling on the
both ISOFIX attachments connectors.
!
Shoulder belt must pass through shoulder belt guide.
!
Waist belt must pass through lap belt guidings.
!
The child restraint can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the child restraint securely.
!
Never use a vehicle waist-only belt across front of child.
!
Do not use shoulder belt loose or positioned under arm.
!
Do not use shoulder belt behind child's back.
!
Do not allow child to slide down in the child restraint in case of strangulation.
!
When not in use, Top Tether MUST be properly stored. To make sure the top
tether is properly stored away, remove any slack in strap to avoid the top
tether swinging around when the vehicle is in progress.
27
3
-
27
31
-
45
46
47
-1
47
-3
47
-2
47
38
Detach Soft goods
see images
-
48
57
1. Press the red button to disengage the buckle.
!
To re-attach the soft goods please repeat the above steps in the reverse
order.
48
50
48
49
51
28