Starting A Programme - Electrolux ESI5545LOX Notice D'utilisation

Masquer les pouces Voir aussi pour ESI5545LOX:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9.1 Using the detergent
A
B
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the
release button locks into position.
9.2 Setting and starting a
programme
The Auto Off function
This function decreases energy
consumption by deactivating
automatically the appliance when it is not
operating.
The function comes into operation:
• 5 minutes after the programme is
complete.
• After 5 minutes if a programme was
not started.

Starting a programme

1. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
2. Close the appliance door.
3. Press Program again and again until
the indicator of the programme you
want to select comes on.
• If you want to select the
MyFavourite programme, press
C
and hold Program until the
MyFavourite setting comes on.
The display shows the programme
duration.
4. Set the applicable options.
5. Press Start to start the programme.
• The washing phase indicator
comes on .
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with
delay start
1. Set a programme.
2. Press Delay again and again until
the display shows the delay time you
want to set (from 1 to 24 hours).
The indicator of the selected programme
flashes.
3. Press Start.
4. Close the appliance door to start the
countdown.
When the countdown is completed, the
programme starts and the washing
phase indicator comes on.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme ends. It
does not happen if the door
is opened by AirDry function.
Do not try to close the
appliance door within 2
minutes after AirDry
automatically opens it as this
may cause damage to the
appliance.
If, afterwards, the door is
closed for at least 3 minutes,
the running programme
ends.
ENGLISH
15

Publicité

Chapitres

Table des Matières
loading

Table des Matières