Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Rest the panels against the appliance.
•
Fit the rear brackets, taking into account the
thickness of the panels (maximum width of unit
900 mm).
•
For a correct alignment make sure that the
distance between the appliance and the cabinet
is of 45 mm.
•
Secure the panels at the front.
•
Check the alignment of the doors, loosening the
fixing nuts and screws and by means of the slots.
•
Tighten the clamp screw on the bottom hinges of
the doors.
•
If necessary, door opening agle max 90° can be
obtained by introducing the pivots supplied
separately. - See picture
Adjustment panels (if necessary)
•
Close the door and check that the small door is
positioned at the required height, removing the
bracket cover and operating the adjustment
screws if necessary.
•
Use the same adjustment screws to align the
doors vertically.
•
Check horizontal alignment of the outer door
panels and, if necessary, correct their position by
moving them along the slots.
•
Open the door.
Adjust the levelness of the small doors by means
of the bracket and small bottom bracket.
•
After aligning the doors, fix the nuts of the bracket
and the screws of the small bottom bracket.
•
Then refit the bracket cover.
L
L
2
2
N
N
N
N
90°
90°
115°
115°
L
L
1
1
=
=
29
Publicité
Table des Matières
