Bosch GLM400CL Consignes D'utilisation/De Sécurité page 35

Press button 11 [–] to browse backwards through the saved
values.
If there is no value available in the memory, "0.000" is shown
at the bottom of the display and "0" at the top.
The oldest value is located in position 1 in the memory, while
the newest value is in position 50 (when 50 memory values are
available). When a further value is saved, the oldest value in
the memory is always deleted.
Deleting the Memory
To delete the content of the memory, press soft key 12 [
then, as many times as required, press soft key 3 [
To delete all values stored in the memory, the function can be
used. Confirm by pressing soft key 12 [
Measured values or end results can be added or subtracted.
Adding Values
The following example describes the addition of areas:
Measure an area as described in section "Area Measurement" ,
see page 30.
09.06.2017
13:20:23
0.0º
185 ft
+
of the second area measurement is displayed below. To show
the end result, press the measurement button 2 [ ] once more.
Note: With a length measurement, the end result is displayed
immediately.
Subtracting Values
To subtract values, press button 11 [–]. The subsequent steps
are the same as for "Adding Values" .
last measured value in all measuring functions.
2610050173 04-18 GLM400CL.indd 35
Adding/Subtracting Values
Press the button 4 [+]. The calculated area and the
symbol "+" will be displayed.
168 ft
2
Press the measuring button 2 [ ] to start another
17 ft 2
area measurement. Measure the area as described
2
in section "Area Measurement" , see page 30. Once
the second measurement is completed, the result
Deleting Measured Values
] and
].
].
9 [ ] will delete the
4/19/18 11:12 AM
35