Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3
Electrical installation
)
Note!
For installation, the documentation of the controller must be observed.
Addressing
The safety address serves to the clear assignment of the safety modules of the SM302 type
in systems with several drives. The address "0" is not permissible.
Address switch
The safety address can be set in the left part of the housing by means of the DIP switch 0.
For setting the switch, use an appropriately small tool, e.g. a probe. The switch can only be
set if the module is not connected to a standard device. The switch serves to set addresses
in the range of 0 ... 1023. Alterations by the switch with regard to the address are only
activated when the 24−V supply is switched on.
ƒ The address setting "0" requires the setting by the address code.
ƒ The address settings 1 ... 1023 are used with priority. The setting by the address code
is not possible.
0
DIP switch
Value of the address bit
EDK94AYAF DE/EN/FR/ES/IT 1.0
1
2
3
1
2
4
l
Electrical installation
Labelling
4
5
6
8
16
32
64
7
8
9
128
256
512
3
0
29
Publicité
Table des Matières
