Pioneer KURO KRP-600M Mode D'emploi page 19

Install Your Flat Panel Display
Connect the speaker cables
(speaker)
Black 
Black
Connect the gray-lined cable to the 
terminals and the black cable to the 
terminals.
Speaker terminals
How to connect the speaker cables
(speaker)
Press the lever and insert the end of
the cable. When you release the
lever, it clamps onto the speaker
cable. Press and hold the lever when
removing the cable.
How to connect the speaker cables
(flat panel display)
Insert the speaker cable connector
securely into the panel's speaker
terminal. To remove the speaker
cable, hold and push the lever then
remove it.
Notes:
• Before connecting the speakers to the flat panel
display, unplug the panel from the power outlet.
Connecting the speaker cable with the power cord
plugged in can cause malfunction or damage to
the panel if the cable's bare wire touches other
equipment. Plug in the power cord after connecting
the speakers.
• Insert the speaker cable straight into the terminal.
Inserting it in an angle will result in a faulty
connection and no sound may come out of the
speaker. If no sound comes out of the speaker,
reinsert the cable.
Connect the speaker cables
(flat panel display)
Red 
Gray lined
Connect the cable with a red connector
to R (right) terminal and the cable with a
white connector to L (left) terminal of the
flat panel display.
Speaker terminals
Speaker cable
• If you insert the speaker cable too far so that
the insulation is touching the speaker
terminal, you may not get any sound. Please
insert it so that the copper wire is still
showing.
• Check if the ends of the speaker cables are
Lever
securely connected to the terminals by slightly
tugging on the cables after making
Lever
connections. Loose connections may result in sound
dropouts or noise.
• If there is a short in the  and  cables caused by an
exposed lead wire, excessive load may be applied to the flat
panel display, resulting in interrupted operation or
malfunction.
• Incorrect connections of the speaker cable to the left or
right flat panel display terminals with respect to polarity
may result in insufficient stereo sound effects, delivering
poor bass sounds or unstable sound image.
• Do not connect any devices to the speaker terminals other
than the speakers specified.
• Excessive force exerted on the speaker cable may cause
connection failures, sound dropouts and/or connector
damage.
• If the speaker cable connector becomes separated from the
speaker cable, consult with your dealer.
(KRP-600M)
Speaker terminals
02
19
En