Ic Radiation Exposure Statement - Klein Tools ET20 Mode D'emploi

COMPLIANCE
FCC RF EXPOSURE INFORMATION (SAR)
This device meets the government's requirements for exposure to radio waves. This device is
designed and manufactured not to exceed the emission limits for exposure to radio frequency
(RF) energy set by the Federal Communications Commission of the U.S. Government.
The exposure standard for wireless devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted
using standard operating positions accepted by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands. Although the SAR is determined at the highest
certified power level, the actual SAR level of the device while operating can be well below the
maximum value. This is because the device is designed to operate at multiple power levels so as
to use only the poser required to reach the network.
In general, the closer you are to a wireless base station antenna, the lower the power output.
While there may be differences between the SAR levels of various devices and at various
positions, they all meet the government requirement.
IC NOTICE TO CANADIAN USERS
This device complies with industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including interference that may
cause undesired operation of the device.
This device complies with RSS-247 of Industry Canada. Operation is subject to the condition
that this device does not cause harmful interference. This Class B digital apparatus complies
with Canadian ICES-003.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
of 5 mm between the radiator and your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.

IC RADIATION EXPOSURE STATEMENT:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 5mm
between the radiator and your body.
EXPOSURE OF HUMANS TO RF FIELDS (RSS-102):
The radiated energy from the antennas connected to the wireless adapters conforms to the
IC limit of the RF exposure requirement regarding IC RSS-102, Issue 5 clause 4. SAR tests
are conducted using recommended operating positions accepted by the RSS with the device
transmitting at its highest certified power level in all tested frequency band without distance
attaching away from the body.
5