Harman JBL GX-A604 Manuel Du Propriétaire page 25

PROBLEM
Sound only comes from some of the speakers
connected to the amplifier
Sound is too quiet, even with the vehicle audio
system's source unit volume all the way up
Sound in the front/rear speakers is distorted
Sound in the subwoofer is distorted
CAUSES AND SOLUTIONS
• C heck that the vehicle audio system's source unit's balance and fader controls are set to their
center (midpoint) positions.
• ( GX-A604): Check that the setting of the amplifier's Mode Switch matches the input and speaker
connections made to the amplifier
• C heck that the amplifier's Level controls are not turned too low. See Set The Input Level, on
page 22, for information about setting the Level controls.
• Make sure the amplifier's Crossover Filter switch for the distorted channels is set to HP.
• Set the Crossover control for the distorted channels to a higher setting.
• Check that the distortion is not originating from the vehicle audio system's source unit.
• (GX-A604, GX-A602): Set the Bass Boost switch to "OFF".
• ( GX-A3001): While listening to bass-heavy music, turn the Bass Boost control all the way down,
and then gradually increase it until the distortion begins to return. Reduce the Bass Boost
control setting slightly to eliminate the distortion and leave it set there.
• Check that the distortion is not originating from the vehicle audio system's source unit.
www.jbl.com 25