Glem GHI9100BK Mode D'emploi page 64

9. Hold up the hood, 16pcs M4*10 big flat screws will be used to connect the hood body into
angle iron, see pic 6.
10. After ensure all the things ok, put down the hook, take from the outside chimney, all the
installation is finished, see pic7.
Carbon filter installation：
(1) Remove the al filter.
(2) Insert the carbon filter in the rectangularhole,fitting it over the motor.
(3) After inserting the front edge of the carbon filter into the slot on the cooker hood. Lower
the back edge of the carbon filter, until it clicks into place at the rear of the rectangular
hole. Raise the two fixing locking plates, until they are perpendicular to the carbon filter.
(4) Place the Al. filter back to position.
Remark:
Install the expansion pipe on the cooker hood if need. Fix the expansion pipe with a cable
tie.(The expansion pipe and cable tie are not supplied with the product. They are optional.)
64