Control Panel - Nilfisk Advance MC1200 Directives D'utilisation

New & Reconditioned Equipment & Parts- www.southeasternequipment.net

CONTROL PANEL

A Separate Circuit Locator Light: This green light will turn on when the two power cords are plugged into separate circuits. Try different outlets with
one cord until you can get a green light, otherwise a circuit breaker in the wall may trip.
B High Pressure/Heat Switch: This selector switch determines whether you will use the 1200 psi pump or the heater. You can select either, but not
both at the same time. The heater will only work with the 500 psi pump. The center position is OFF, and neither the 1200 psi pump nor the heater is
turned on. CAUTION: do not operate the 1200 psi pump and the 500 psi pump at the same time.
C 1200PSI Indicator Light: This light will turn on when the switch is set to the 1200 PSI pump.
D Vacuum Switch: This switch turns on the vacuum.
E 500PSI Pump Switch: This switch turns on the 500PSI solution pump. CAUTION: do not run both solution pumps at the same time.
F Dump Pump Switch: This last switch turns on the automatic pump-out pump. Use this when you want the machine to automatically pump out the
recovered solution. CAUTION: do not turn on this pump until you have connected the pump-out hose.
G Heat Indicator Light: This light will turn on when you have selected heat instead of the 1200 psi pump.
B
A
9/2016
New & Reconditioned Equipment - www.southeasternequipment.net
INSTRUCTIONS FOR USE
D
C
G
E
F
56042670 - MC1200
ENGLISH - A
A-7