Snapper SXD19SSWM82 Manuel D'utilisation page 17

ASSEMBLY
TO INSTALL BATTERY PACK (See Figure 7)
• Lift and hold up the battery door (1).
• Align the battery (2) with the lawn mower's battery port.
• Make sure the battery release button (3) snaps in place and that battery is
fully seated and secure in the lawn mower before beginning operation.
• Close the door.
(1)
TO REMOVE BATTERY PACK (See Figure 7)
• Release the bail lever to stop the lawn mower.
• Open the battery door (1).
• Press the battery release button (3) on the lawn mower. This will cause
the battery (2) to raise out of the tool slightly.
• Remove battery from the lawn mower.
(2)
17
(3)
Fig. 7