Flow Sensor Settings; State Switch Of A Flow Sensor - Rain Bird TBOS Serie Manuel D'utilisation

ENG
When the sensor is activated (open –
it is raining) programs keep on proceeding normally but valve outputs are deactivated.
- If rain starts when irrigation is processing, the valve currently working is stopped (but programs keep on proceeding)
- If rain starts when irrigation is closed, valve outputs are deactivated and despite programs are processing,
irrigation does not start as scheduled.
- If sensor state comes back to normal state (closed) during planned irrigation, the current valve starts for
the remaining duration in the current program.

3. Flow Sensor Settings

Available on TBOS-II
TM
- When connected to a TBOS-II Controller,
from the Main Menu select "Check programs",
select "Sensor parameters"
- 3 screens allow to set-up all configurations:

WARNING: The user sets-up a settling time (1 to 10 minutes) – Corresponds to the time during which the over
consumption has to be observed before the program gives the alert.
If the consumption is above the threshold for a duration exceeding the settling time set-up by the user, then
an over-flow alert is launched and prevent irrigation until the alert clearance by user.

4. State switch of a flow sensor

The reactions for the state switch of a flow sensor are the alert and the selection of none affected valves.
Only IQ Software is able to display flow count.

Please read the HELP Section of IQ
offset,...)
30
centralized on IQ V2 only.
software to set up your sensor (settings, alert thresholds, K factor and
TM
Installation Schematic of a RSD-Bex
Rain Sensor


