Radio Marking Of Tbos-Ii Products - Rain Bird TBOS Serie Manuel D'utilisation

1. Radio Marking of TBOS-II

WARNING : Radio marking is a KEY STEP of radio device installation. WARNING : Radio marking is a KEY STEP of radio device installation.
During Radio marking, TBOS-II Field Transmitter sends its own Radio Network number to the radio device marked.
The Radio Network number is a 4-digit code transmits by the Field transmitter to every radio device marked with this Field
Transmitter.
3 Steps
1/ Go on Radio Marking Screen on the Field Transmitter (TBOS Radio Menu / Radio Marking)
2/ Activate the "Waiting Network number" mode on the radio device - this mode is activated
during 20 seconds.
- For a Radio Adaptor: Unplug (for 5 seconds)/Plug the Radio Adaptor battery
- For a TBOS Radio Relay: Turn the initialization trigger (3 times)
- For an IQ-TBOS Master Radio Module: Unplug/Plug the module on ESP-LX back plate
3/ Validated by pressing OK on the Field Transmitter within 20 seconds.
Radio marking is performed only once in the lifetime of the product (the first time it is used after leaving the factory) or if the
user moves a Radio Adaptor unit from one site to another (E.g. site 1 with network number 0001, site 2: 0002, etc.).
- To wake-up the Field Transmitter, press HOME during 2 seconds.
- Press OK and select ''TBOS Radio" – Confirm with OK.
- The select "Radio marking" from the TBOS™ Radio menu.
A message will then appear on the screen.

UNPLUG THE RADIO ADAPTOR BATTERY AND PLUG IT AGAIN (unplug-plug to initiate the marking
process). Then you have 20 seconds to validate radio marking on the Field Transmitter by pressing OK.
If radio marking has failed, the message "FAILURE
CODE 1" will be displayed after a few seconds
(1 indicating a radio error). If marking has been
performed correctly, the message "SUCCESS"
will be displayed on the screen, followed by the
unique identification code of the radio device just
tagged (12 digits).
Products
TM

25
ENG